Colette Aster

1 Colette Aster side view1 Front ViewBack in May when Colette introduced their latest pattern, a few critics commented that Aster was unambitious and sadly lacking those vintage-inspired details that once differentiated Colette from the ‘Big 4’.  I needed a blank canvas on which to experiment with collar design so I bought the downloadable version ($12) and tested it by sewing Version 1 using some dyed calico that had been festering in my stash.  No frugality was spared in the making!  The large buttons were ripped off an old Boden shirt.  I think they contribute to a very ‘Eastern totalitarian regime’ look that I can’t help returning to from time to time.  Even the blue is the exact shade of the envelopes used during my 10 years of growing up in Yugoslavia (there was never much variety in the stationery available – that is a capitalist affectation!)

Ignore the too-tiny collar which would have been more in proportion had it been 5.5cm instead of 4cm deep but I ran out of fabric.  Next time I make Aster, I promise the collar will steal the show!

1 Colette Aster YokeI don’t consider myself a beginner so I was quietly entertained during the sewing process when Aster showed me a couple of new tricks!  Firstly, the all-clean method of sewing the yoke so that it looks the same on the inside as on the outside.  colette aster yokeThis is unofficially called the Burrito method and is nowhere near as complicated as this diagram suggests.  If you want to give it a go but without Aster, Grainline Studio does a Burrito tutorial here.

1 Tuck bias binding into placket

Secondly, I picked up this smart method  of finishing the neckline with bias binding, the ends of which are tucked into the placket on the inside of the garment.  It’s not difficult to do neatly but ensure you tailor-tack the clipping point accurately.

Likes

  • A good fit.  I achieved this by cheating somewhat: I went down from 6 to 4 (I’m cup B and Colette patterns are sized for a cup C) which saved me from the shame! hassle of having to do a small bust adjustment.
  • It’s so quick to make, thanks to the bias-bound neckline.
  • The variations offered by the three versions mean that you can create quite a few wardrobe staples, none of which need to be as bland as my muslin.

1 colette aster technical drawing

Dislikes

  • This is the umpteenth time it’s happened but there just isn’t enough length in those gathering stitches that round the sleeve cap.  If you look closely, see how much excess is at the sleeve back?  That’s because I couldn’t line up the apex with the shoulder seam.   I suggest you extend the gathering stitch area by an inch on both sides and you’ll have more control when attaching the sleeve.
  • Hemming instructions are oddly taciturn.  Don’t hem at the end as instructed.  Use my method as it’s easy and looks better.  Important: you need to go through these steps before sewing the vertical seams of the placket!
1 Fold under seam allonwanc

Fold and press placket as in the instructions but don’t stitch. Fold and press the 1.5cm (5/8″) Hem allowance

Fold half the hem allowance under and press. Pin up to the placket. Clip corner. Make a small nick in the bottom of the placket fold to reduce bulk when it is folded in the next step.

Fold placket along pressed edges and pin. Stitch entire hem including the placket. Finally, stitch the vertical seams of the placket.

 

Conclusion

I’m impressed by this unassuming number.  It’s well-fitting, easy and versatile.  And I learnt something.

I leave you with my Worker’s Elbows pic!

1t Colette Aster Back View