PDQ PDF

Printing patterns in PDF (Portable Document Format) is seen by many as something of a PITA (Pain in the Ass)!  I quite enjoy it; it’s like putting together a not-too-taxing floor puzzle.  Both Burda and Colette suggest using sticky tape in their guides on “how to put together PDF patterns” but a glue stick is pretty darn quicker since you cut (or fold back) half the margins.  Let me demonstrate.

1 cut marginTake two sheets that fit together, left to right.  Cut off the right side margin of the sheet on left.  1 trim right hand side margin, cover left hand side margin liberally with glue

Rub a streak of glue on the margin of the corresponding sheet.

1 stick

Stick the trimmed sheet to sticky margin.

If you’re unhappy with the placement, you have a few seconds before the glue dries to remove the sheet and re-apply.

Once you have completed a row, trim off the bottom margin of the entire row and stick to the top margin of the row below.

Work systematically, completing the assembly row by row as you would with tape.  Be  consistent, always cutting for example the right-hand-side margins and the bottom ones.  This Colette Aster, Version, 1 took me under 20 minutes to assemble.  As you can see, there’s a page missing.  By using Print Preview, I realised one of the pages didn’t have any part of the pattern on it so it didn’t get printed.  This may not have saved time, just paper!1 aster pdf in under 20 minsAnother advantage of using a glue stick is that you don’t get the gaps in between strips of tape.  Oh yeah, and you can run an iron over without melting anything!

Do you use the glue method or do you prefer Sellotape or Scotch Tape?  If so, why?